A mechanical-detachable extendable lowbed with tandem rear axles. Its closed and extended well references distinguish the support geometry needed for different load lengths.
The selected open or closed state belongs with its own dimensions and rating chart.
Loading path
Front detach
Establish the required extension, locking position and loading sequence using the manufacturer’s procedure. Check the trailer in its transport state after loading.
Supporting the load
An open telescoping span is not necessarily continuous flooring. Confirm the cargo’s permitted support positions and the extension-specific chart.
Other configurations of this model
Compare the changes in height, coupling or extension state before switching references.
6 ft 9 in2,057 mm · Manufacturer stated; loading condition not specifiedSource ↗
Axle spacing
4 ft 6.5 in1,384 mm · Manufacturer stated; loading condition not specifiedSource ↗
Still needed from the build sheet
Overall transport length
Main deck / well length (nominal)
Upper-deck length
Deck transition drop
Usable support width
Ratings & support conditions
The exact build’s load chart is required. A model-family capacity range does not establish this configuration’s rating.
Tare, gross vehicle rating and structural load ratings describe different limits. None alone establishes allowable payload or legal axle loads.
Plan around the actual load
These applications identify what to investigate. Suitability depends on the transported assembly, support points and the selected trailer build.
Excavators
Will the stowed machine fit the well?
Track footprint length alone is insufficient. Record where the rollers react into the tracks, and check side rails, outriggers and the position of the machine centre of gravity.
Rating basis: 40 tons in 16-foot length - GAWR and tire ratings determine legal loads
Match the selected deck, neck and axle configuration to the actual build sheet.
Read the complete capacity and support conditions at the source; a model-family rating is not automatically transferable.
Equipment selection requires verified weights and ratings, load support, coupling and axle analysis, securement planning and route review. This reference is not engineering, permit or route-clearance approval.
