Landoll
330-1
Single-axle Landoll 330-1 hydraulic traveling-axle container trailer, distinct from the current two-axle 330-2.
What the documentation establishes
- Trailer family
- Traveling / Sliding Axle →
- Loading method
- Hydraulic tilt and traveling axle for container loading
Choose by the documented loading system and configuration notes first. Request a dimensioned build drawing before comparing this model with a measured load.
A model name or nominal class does not establish usable payload. The rating conditions and build-specific questions below remain part of the selection.
Know the space. Know the limits.
The reference does not establish this measurement.
7 measurements to confirm
Request these values for the actual configuration. An absent value is not zero and does not establish a fit.
- Main deck / well length (nominal)
- Not documented
- Overall transport length
- Not documented
- Overall / side-rail width
- Not documented
- Usable main deck / well length
- Not documented
- Usable support width
- Not documented
- Upper-deck length
- Not documented
- Rear-deck length
- Not documented
- Main-deck height
- Not documented
- Ground clearance
- Not documented
- Kingpin setback
- Not documented
- Swing clearance
- Not documented
- Coupler height
- Not documented
- Axle spacing
- Not documented
- Gooseneck length
- Not documented
- Main hydraulic tail length
- Not documented
- Deck transition drop
- Not documented
- Loading ramp length
- Not documented
- Tail fold-under length
- Not documented
Overall length is not usable deck length. A published side-rail width does not establish the unobstructed support width. Values above come from documentation, not from image measurements.
Capacity with its conditions
No comparable payload rating is established by this reference. Obtain the configuration-specific load chart.
Structural ratings do not approve axle loads, the tractor connection, route clearance or a permit.
What to verify
- 42 ft, 48 ft and 50 ft forms remain configurations; current document dates are not introduction dates.
- Obtain the exact Landoll build sheet and option schedule before numeric fit decisions.
- Length, suffix, axle, tail and extension choices remain configurations unless the production master defines a separate identity.
- Loading method
- Hydraulic tilt and traveling axle for container loading
- Axle arrangement
- Single traveling axle
Manufacturer configuration detail
- Frame rating
- 8 ton / 16,000 lb manufacturer statementManufacturer source ↗
- Concentrated-load statement
- 10,000 lb in 10 ftManufacturer source ↗
- Standard loading angle
- 12 degreesManufacturer source ↗
Documentary statements retain their original conditions. Only unambiguous numeric fields enter dimensional checks.